1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Automating pitch question.

Discussion in 'Logic Pro X' started by joshman108, Sep 30, 2013.

  1. joshman108

    joshman108 New Member

    Hey. So I'm doing an edm build with a long note that I want to bend up over like, 8 measures.

    I'm using massive, and then adjusting the osc 1 pitch from logic's automation.
    Its working great, but it only moves in whole notes. I want it to move over the whole cent spectrum.

    Any suggestions?

  3. Per Boysen

    Per Boysen Senior member

    Adjust pitch-bend range on the instrument.
  4. joshman108

    joshman108 New Member

    thats not possible because I'm going to move it like 2 octaves in 8 bars and the instrument only lets you move like a couple notes when you're on the cent spectrum.

    Unless you know something I dont.
    Plus, I would have to use the latch function doing it that way wouldnt I? Latch is so... human and uneven. Automation is so smooth.
  5. Peter Ostry

    Peter Ostry Administrator Staff Member

    You may have to pitch the audio.

    Best pitcher for creative work I know:
    QuikQuak Pitchwheel
    4 octaves maximum
    Automation for all parameters

  6. Tangra

    Tangra Senior member

    That's correct. Logic TBA is not capable to support the fine cents you want to automate...
    As was offered above you can use Pitch Bend instead, though it may result a little bit steppy...
    Set the Pitch Bend range in Massive as shown in the image:
    1. Click the "OSC" menu.
    2. Set the PB range.
    3. Draw 8 bars Pitch Bend automation line in the Piano Roll Hyper Draw.




Share This Page