1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Axiom 25 Rotary Controller Assignments

Discussion in 'Logic Pro X' started by Steve Jorgensen, Aug 5, 2013.

  1. Steve Jorgensen

    Steve Jorgensen New Member

    I tried to map a knob on the Axiom 25 keyboard controller to a Smart Control in Logic Pro X using learn. It learned the knob assignment, but didn't work right. When I turned the knob on the Axiom 25, the Smart Control knob just jumped between minimum & maximum positions.

    By experimenting in the Controller Assignments, Expert View, I was finally able to make it seem to work. I'm far from certain that it works right reason though or in the most straightforward way. Also, if I have to change these things after every time I map a knob, it's going to be severely annoying.

    Any advice?

    What I did in the Expert View that finally seemed to work was...

    1. Change "Format" from "2's Complement" to "1's Complement".
    2. Change "Multiply" from 1.0 to -0.1 (was moving way too fast & in the wrong direction otherwise)
    "Mode" was already "Relative" & no other mode seems to work regardless of other settings.
     
  2.  

Share This Page