Sample Aid
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Logic 9 Scrambled Inputs

Discussion in 'Logic 9' started by Steve Pogson, Oct 20, 2011.

  1. Steve Pogson

    Steve Pogson New Member

    Hi all,

    had an interesting but slightly embarrassing moment yesterday whilst trying to record a singer and I could get no signal on the input channel though the sound was registering on my interface (2xMotu 2408mk3 and 1x8pre - Focusrite Twin-Trak Pro feeding SPDIF inputs of 1st 2408).

    Luckily the session was finishing and when I had chance to investigate I found that all my input channels had moved to different virtual locations (8pre 3 (set up for guitar) is now 8pre7!)

    The setup has been working fine for ages so why should all the inputs move around? Any ideas?

    Cheers, Steve
     
  2.  
  3. Doug Zangar

    Doug Zangar Senior member

    I haven't used that interface, but I'm wondering if the switch didn't occur there rather than in Logic. Can you assign inputs to specific outputs?
     
  4. Steve Pogson

    Steve Pogson New Member

    I think it might be to do with the order I fire up the interfaces and the computer. I'm going to experiment tomorrow.

    Thanks for the reply

    Steve
     

Share This Page