This is probably stupid but I can't find it in the manual: I want an automated cycled recording with a punch in region inside the cycle. So, say I want bar 1-8 to repeat over and over but I only want to record on bar 3-5. Also I want each cycle to create a new region on top of the previous one. So I set L/R to 1/8 and Punch In/Out to 3/5. Press record. Works nicely - one time! Then goes out of record mode. Why? If I use cycle only it will record over and over - exactly like I want - but then I can not prelisten bars before the point where I want to record.