1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

using automap

Discussion in 'Studio Techniques' started by NICEDJS STUART, Dec 28, 2012.

  1. NICEDJS STUART

    NICEDJS STUART New Member

    i just got an impulse49 with automaping anyone using this any good tips for automaping???:hippy:
     
  2.  
  3. CSeye

    CSeye Senior member

    Congratulations.

    Follow the set up instructions carefully.

    See this:
    http://www.novationmusic.com/answerbase/en/article.php?id=704
    Look at the attached Hook up screen grab.

    I would initially set up Automap with Logic in 32 bit mode to be authorized by Logic's plug-in manager.

    If you are going to run Logic in 64 bit mode, then make sure you check on "Use Logic 9 64-bit friendly Audio Units" in the Automap Preference. Otherwise, Logic will rescan all of your plug-ins each and every time you start up Logic.
     

    Attached Files:

  4. Atlas

    Atlas Senior member

    I strongly reccomend that you follow religiously the procedure as described in the Novation Automap installation that came with your keyboard!
    No place for improvisation here!
    Otherwise it is almost certain that you will be a good Tylenol customer, and that you will end up having to go through the book-step-by-step procedure anyway...

    Here is a previous post regarding the Automap update procedure that you will eventually have to go through, it also include some other useful information, especially if you use more than one type of MIDI controller.

    May I also suggest that you post your setup info in your signature...
     
  5. NICEDJS STUART

    NICEDJS STUART New Member

    i need to uninstall automap 4 as i sent my novation impulse back as it was faulty, but i cannot fully uninstall and now when i go to install new disc it will not let me any help would be grateful
     

Share This Page